Toyotomi EPH-121 Manuel d'utilisateur Page 5

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 16
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 4
4
More
than
30cm
More than 100cm
More than 100cm
More
than
30cm
Do not use this heater without the frame.
The product will tip over and it can result in an injury.
Do not use this heater to warm your pets such as dogs and cats.
Your pets may break the body or power cord and it causes a fire.
The Panel heater is not allowed to be used in such a moist place as a
bathroom.
An electric shock or malfunction may occur.
In the early stage of use, volatile organic compound and carbonyl
compound will be produced and it will smell. In that case let fresh air in
sufficiently.
The odor will be lesser by continuing to use of this heater.
Do not put clothes or something foreign materials between
front panels of the product and do not put something in front
of (in a radiation direction) the front panels.
It causes a fire and a breakdown. Keep the isolation distance
between the product and the flammables.
Use this heater by keeping each distance
described on the right between the product
body and the flammables. However one
side or the other side shall not face to the
wall or the furniture.
CAUTION
When this heater is left plugged in and turned on or off, the previous turn-off information is stored
in the microcomputer. And when this heater is turned on again, it runs with that information stored.
However when this heater is unplugged, the information stored in the microcomputer will be
deleted.
Temperature will be automatically controlled so the cricking sound will be made every time when
the mica-heater is switched on or off. It is the sound to switch on or off inside the controller and it
is not defect.
Because this heater is used in the room where get hot easily or affected by other heating
appliance or with the opening for the ventilation blocked, if inside the body is overheated, the
overheat protection system will work and stop all operations. In that case, remove the overheat
causes and let the product cool first, then run it again. If the overheat protection system still
activates after removing the causes and all operations are stopped, contact the shop where you
bought the product.
INFORMATION
EPH-121-T.qxd 11.11.18 10:56 AM ページ 4
Vue de la page 4
1 2 3 4 5 6 7 8 9 10 ... 15 16

Commentaires sur ces manuels

Pas de commentaire